Arma 2 config file update#

Example: A unit 1km (distance d = 1km) from the player with MinErrorToSend = 0.001 (METS = 0.001) would send an update when that unit moves 50m (error value E = 50).

Used to control client to server traffic as well. Using larger value can reduce traffic sent for near units. Minimal error to send updates across network for near units. Using a smaller value can make units observed by binoculars or sniper rifle to move smoother at the trade off ofДefault: 0.001 ( was 0.01 until ARMA 2:OA version 1.60, ARMA 2 version 1.11 uses 0.01) Minimal error to send updates across network. This value helps the server to estimate bandwidth available. Increasing it to too optimistic values can increase lag and CPU load, as too many messages will be sent but discarded.Д«andwidth the server is guaranteed to never have (in bps). This value helps server to estimate bandwidth available. Increasing this value may improve bandwidth requirement, but it may increase lag.Д«andwidth the server is guaranteed to have (in bps). Non-guaranteed packets (aggregate messages) are used for repetitive updates like soldier or vehicle position. Maximum size (payload) of non-guaranteed packet in bytes (without headers). Guaranteed packets (aggregate messages) are used for non-repetitive events like shooting. Small messages are packed to larger packets (aggregate messages). Maximum size (payload) of guaranteed packet in bytes (without headers). Increasing this value can decrease lag on high upload bandwidth servers. Maximum number of packets (aggregate messages) that can be sent in one simulation cycle ('frame'). You can add following entries to arma.cfg (the main Armed Assault configuration file) There are also some parameters that can be used to fine-tune network performance. In this configuration file you should configure your server's connectivity, mainly for performance tuning. (For Arrowhead the name is ArmA2OA.cfg, for Arma 2 it is arma2.cfg). cfg file is loaded with a name depending on a product, located in the Documents area of the OS user profile. When you do not provide a name, a default. The real name is determined by the -cfg command line option when launching the dedicated server or the game executable - in other words it also works for clients. This article deals with the basic.cfg, the name means nothing, and can be called anything. For a dedicated Arma 3 page, see Arma 3: Server Config File.

Arma 2 config file